The effect of detonation spraying on the phase composition and hardness of Al2O3 coatings
Abstract
The article were studied the e ect of detonation spraying on the structure and properties of Al 2 O 3 coatings. It was determined that reducing the delay time between shots is leading to increase the hardness and elastic module of Al 2 O 3 coatings. It was found on the basis of X-ray di raction analysis that the main reason for the increasing in hardness with a decreasing in the delay time between shots is associated with increasing in the volume fraction of α -Al 2 O 3 phase. The studies of X-ray di raction presented that the highest content of the phase is achieved when the coatings are formed with a delay time between shots of 0.25 s. It was found that increasing in the volume fraction of the α -Al2O3 phase is caused by the secondary recrystallization γ → α , which occurs due to the heating of particles during coating formation, i.e. due to increasing in temperature above 1100 ◦ C in single spots of the coating when they are put each other.
Recommended Citation
Rakhadilov, B. K.; Buytkenov, D. B.; Kakimzhanov, D.; Kozhanova, R. S.; and Bektasova, G. S. (2020) "The effect of detonation spraying on the phase composition and hardness of Al2O3 coatings," Eurasian Journal of Physics and Functional Materials: Vol. 4: No. 2, Article 7.
DOI: https://doi.org/10.29317/ejpfm.2020040207
References
Downloads
Published
Issue
Section
License
The Eurasian Journal of Physics and Functional Materials is an open-access journal. Articles published under the Creative Commons Attribution 4.0 International License (CC BY 4.0) may be shared, redistributed, and adapted, including for commercial purposes, provided that the terms of the license are followed, including appropriate attribution to the original authors and source.
License: https://creativecommons.org/licenses/by/4.0/
Copyright ownership and publication rights are governed by the terms applicable to each article and the relevant author agreement.
