Study of the effect of combined reinforcement and modification of epoxy resin with rubbers on the impact strength of carbon fiber-reinforced plastic
Abstract
The effect of modified epoxy resin with polyurethane, silicone, and butadiene rubber and combined reinforcement with fiberglass and Kevlar on the strength properties of carbon fiber-reinforced plastic was studied. It was found that when rubber is introduced into the composition of the epoxy resin, polyurethane, and combined reinforcement according to the carbon fiber/Kevlar scheme in a ratio of 10:10 leads to an increase in impact strength by 42% to 273 kJ/m2 and compressive strength increases by 35% to 575 MPa
Recommended Citation
Meiirbekov, M. N.; Ismailov, M. B.; Kenzhegulov, A. K.; Mustafa, L. M.; and Tashmukhanbetova, I. B. (2024) "Study of the effect of combined reinforcement and modification of epoxy resin with rubbers on the impact strength of carbon fiber-reinforced plastic," Eurasian Journal of Physics and Functional Materials: Vol. 8: No. 1, Article 3.
DOI: https://doi.org/10.32523/ejpfm.2024080103
References
Downloads
Published
Issue
Section
License
The Eurasian Journal of Physics and Functional Materials is an open-access journal. Articles published under the Creative Commons Attribution 4.0 International License (CC BY 4.0) may be shared, redistributed, and adapted, including for commercial purposes, provided that the terms of the license are followed, including appropriate attribution to the original authors and source.
License: https://creativecommons.org/licenses/by/4.0/
Copyright ownership and publication rights are governed by the terms applicable to each article and the relevant author agreement.


