Mechanochemical synthesis and structural and phase characterization of composite inert matrices in the ZrO2 - Nb2O5 system
DOI:
https://doi.org/10.32523/ejpfm.2026100401Keywords:
mechanochemical synthesis, zirconia ceramics, ZrO2 - Nb2O5 system, phase transformations, microhardness, microstructure, flexural strength, dispersion strengtheningAbstract
A relationship was established between phase transformations, microstructural evolution, and the strengthening of ZrO2 - Nb2O5 composite ceramics obtained by mechanochemical solid-state synthesis followed by annealing at 1500 °C. The Nb2O5 content was varied from 0 to 50 wt.% in increments of 10 wt.%. Phase composition and structural changes were studied using X-ray diffraction and Raman spectroscopy, while grain morphology was examined by scanning electron microscopy. Mechanical properties were assessed using Vickers hardness and flexural strength measurements. The addition of Nb2O5 promoted the formation of the niobate phase Nb2Zr6O17, accompanied by changes in grain morphology and relative grain refinement. At 20 – 30 wt.% Nb2O5, Nb2Zr6O17-rich ceramics with a relatively fine-grained microstructure exhibited the highest hardness and flexural strength values. At higher Nb2O5 contents, additional phases, including Nb2O5 and tetragonal ZrO2, were detected, accompanied by morphological changes and reduced hardness and flexural strength. The observed strengthening correlates with phase composition and grain morphology; contributions from solid-solution effects, dispersion strengthening, and residual stresses remain possible but require independent verification.
References
[1] W.D. Kingery, H.K. Bowen, D.R. Uhlmann, Introduction to Ceramics, 2nd ed. (John Wiley & Sons: New York, 1976) 1032 p.
[2] C.B. Carter, M.G. Norton, Ceramic Materials: Science and Engineering (Springer: New York, 2007) 716 p.
[3] M.N. Rahaman, Ceramic Processing and Sintering, 2nd ed. (CRC Press, 2017) 875 p.
[4] B. Stawarczyk et al., Clinical Oral Investigations 17 (2013) 269–274.
[5] G. Kabdrakhimova et al., Open Engineering 16 (2026) 20250160.
[6] R.A. De Souza et al., Solid State Ionics 196 (2011) 1–8.
[7] Z. Zeng et al., Journal of the European Ceramic Society 39 (2019) 4338–4346.
[8] J.E.M. Lopes et al., Ceramics International 42 (2016) 861–873.
[9] M. Kantcheva, H. Budunoglu, O. Samarskaya, Catalysis Communications 9 (2008) 874–879.
[10] T. Miruszewski et al., Journal of The Electrochemical Society 171 (2024) 034503.
[11] R.J. Spurling et al., Journal of the American Ceramic Society 107 (2024) 6868–6875.
[12] O. Abdirashev et al., Int. J. Mol. Sci. 27 (2026) 7975.
[13] E.O. Hall, Proceedings of the Physical Society. Section B 64 (1951) 747–753.
[14] N.J. Petch, Journal of the Iron and Steel Institute 174 (1953) 25–28.
[15] Y. Huang et al., Materials 18 (2025) 2605.
[16] C. Suryanarayana, Progress in Materials Science 46 (2001) 1–184.
[17] P. Balaz, Mechanochemistry in Minerals Engineering, in: Mechanochemistry
in Nanoscience and Minerals Engineering (Springer: Berlin, Heidelberg, 2008) 257–296.
[18] Y. Zhang et al., International Journal of Applied Ceramic Technology 21 (2024) 616–654.
[19] J. Sakfali et al., Journal of Photochemistry and Photobiology A: Chemistry 430 (2022) 113970.
[20] D.Y. Lee, J.W. Jang, D.J. Kim, Ceramics International 27 (2001) 291–298.
[21] J.E.M. Lopes et al., Ceramics International 42 (2016) 861–873.
[22] N. Hossain et al., Journal of Materials Science: Materials in Electronics 30 (2019) 9822–9835.
[23] U. Balachandran, N.G. Eror, Journal of Materials Science Letters 1 (1982) 374–376.
[24] A.J. Moreira et al., Research on Chemical Intermediates 49 (2023) 2855–2874.
Downloads
Published
Issue
Section
License
Copyright (c) 2026 A.T. Zhumazhanova, R.I. Shakirzyanov

This work is licensed under a Creative Commons Attribution 4.0 International License.
The Eurasian Journal of Physics and Functional Materials is an open-access journal. Articles published under the Creative Commons Attribution 4.0 International License (CC BY 4.0) may be shared, redistributed, and adapted, including for commercial purposes, provided that the terms of the license are followed, including appropriate attribution to the original authors and source.
License: https://creativecommons.org/licenses/by/4.0/
Copyright ownership and publication rights are governed by the terms applicable to each article and the relevant author agreement.


