Development of electroforming method for coating of polymer membranes by graphene oxide
Abstract
The current research is focused on development of electroforming method for coating of porous membranes by graphene oxide. A mixture based on polymethylmetacrylate dissolved in acetone and graphene oxide was pumped through the syringe pump onto the needle and high voltage was applied to both electrodes, one of which was on a glass plate, and the second was a needle thereby forming fibers, which coated the surface of membrane uniformly. The main parameters and concentrations of used polymer for uniform and complete coating of the surface of membrane are studied. Surface morphology of coated membranes was studied by SEM.
Recommended Citation
Sultanov, F. R.; Daulbayev, Ch.; Bakbolat, B.; and Mansurov, Z. A. (2018) "Development of electroforming method for coating of polymer membranes by graphene oxide," Eurasian Journal of Physics and Functional Materials: Vol. 2: No. 2, Article 2.
DOI: https://doi.org/10.29317/ejpfm.2018020202
References
Downloads
Published
Issue
Section
License
The Eurasian Journal of Physics and Functional Materials is an open-access journal. Articles published under the Creative Commons Attribution 4.0 International License (CC BY 4.0) may be shared, redistributed, and adapted, including for commercial purposes, provided that the terms of the license are followed, including appropriate attribution to the original authors and source.
License: https://creativecommons.org/licenses/by/4.0/
Copyright ownership and publication rights are governed by the terms applicable to each article and the relevant author agreement.
